Technical requirements for pipe elbows

Author : admin

Update time : 2021-08-23 15:43:39

The curvature radius of stainless steel elbow shall be controlled. For example, if the radius length is 1.5D, the radius of curvature must be within the required tolerance. Since most of these pipe fittings are used for welding, in order to improve the welding quality, the ends are turned into grooves, with a certain angle and a certain edge. This requirement is also strict. There are provisions on the thickness of the edge, the angle and the deviation range, and there are many more geometric dimensions than the pipe fittings. The surface quality and mechanical properties of elbow are basically the same as those of pipe. For the convenience of welding, the material of steel shall be the same as that of the connected pipe.
1. Since most of the pipe fitting elbows are used for welding, in order to improve the welding quality, the ends are turned into grooves, with a certain angle and a certain edge. This requirement is also strict. There are regulations on the thickness of the edge, the angle and the deviation range. The surface quality and mechanical properties are basically the same as those of pipes. For the convenience of welding, the steel grade of pipe fittings and connected pipes is the same.
2. That is, all pipe fittings shall be subject to surface treatment, and the iron oxide scale on the internal and external surfaces shall be sprayed off by shot peening, and then coated with anti-corrosion paint. This is for export needs. Moreover, this work should be done at home to facilitate transportation and prevent corrosion and oxidation.
3. It is the requirement for packaging. For small pipe fittings, such as export, wooden boxes need to be made, about 1m3. It is stipulated that the number of pipe fitting elbows in such boxes can not exceed one ton. The standard allows suits, that is, large sets and small sets, but the total weight can not exceed 1 ton. For large pieces y, a single package is required. For 24 ", a single package is required. The other is the packaging mark, which should indicate the size, steel number, batch number, manufacturer's trademark, etc.

Previous : Stamping process of carbon steel elbow

Next : Analysis of main causes causing quality decline of elbow and precautions

ASME B16.9 Stainless Steel Elbow Dimension

Apr .17.2024

We are high quality 90 Degree ASME B16.9 ASME A403 WP304 4 Inch Butt Weld Stainless Steel Elbow manufacturer in China.

The processing method of flanges

Apr .15.2024

Forging method. Machining flanges through forging can be divided into two types: free forging and die forging. Free forging involves compression processing under a forging press